Acro Naze32 REV6 Flight Controller (Straight + Right Angle)

Drone Proz

$ 24.95 
SKU: 4003

Sorry, this item is out of stock

Share:

The newest version, rev6, of the popular Acro Naze32 FC

At the heart of the Naze32 is a 32bit ST micro work horse of a processor, with untapped memory and cpu power and a host of equally impressive sensors. The Naze is also matched up with some of the nicest GUI programs and features to get the most out of your configuration.

This "Acro" version is the same as the full Naze32 board except the full version comes with the MS5611 barometer and a magnetometer. 

  • STM32F103CBT6 32-bit ARM Cortex M3 processor (72MHz, 3.3V)
  • Invensense MPU6500 MEMS accelerometer + gyro
  • BMP280 Barometer
  • Built-in Micro-USB for programming/firmware update
  • 36x36mm size, ~5 gram weight w/o headers
  • Shipping with 16V input capable voltage regulators

These come with pin headers (straight and right angle options), NOT soldered to the board. 

 

Here are the changes / improved features compared to previous Naze32 Rev5 Acro

  • USB Port on the right side
  • PPM/PWM input as through-hole (it used to be solder pads, and caused some problems when overheat the pads pulled off)
  • SBUS Inverter (so people won’t have to do the inverter hack on their x4r with Naze32, but it doesn’t seem to support smart port so might not do telemetry. Will confirm later)
  • Onboard 2MB flash (useful for blackbox)
  • Built-in BMP280 barometer (Not sure what you can use it for on a Acro board flying rate mode, but better than none I guess)
  • Fully pinout compatible with rev5 accessories (OSDoge etc)
  • Compatible with Spectrum satellite
  • Sonar pads with resistors added for direct connection to 5V sonar
  • All extra pads (FT, GP, A5) on top, only sonar on bottom
  • 3.3V, I2C on standard-size headers

 

  • Configuration software found HERE (Chrome)